Which connector is used for 10base t network cables

In general, the patch cords that you use with your Ethernet connections are "straight-through", which means that pin 1 of the plug on one end is connected to pin 1 of the plug on the other end. In this particular case it is not then important to wire them as above. Pin 1 is Pin 1 etc etc. However for the sake of uniformity it may be best to wire your cables with the same colour sequence. Cross-Over cables are "crossed" end to end data cables aren't.

If you have a network hub that has an uplink port on it then you do not need to make or purchase a cross-over cable. Just switch the port on the hub to the 'uplink' mode. If your hub does not have an 'uplink' port on it then the only way to cascade another hub or attach a cable modem is to use a cross-over cable.

It helps for future reference to mark or attach a tag to the cross-over cable so that you do not attempt to use it as a 'normal' patch lead at some time in the future. This can be two computers connected without a hub, or two hubs via standard Ethernet ports in the hubs. Then you need a "cross-over" patch cable, which crosses the transmit and receive pairs, the orange and green pairs in normal wiring. In a cross-over cable, one end is normal, and the other end has the cross-over configuration.

Remember you can only network two computers together with Cat5 cable. To add extra PC's to your network you will require a hub. When working with 10Base-T wiring, concentrators, and adapters from different vendors, it is possible to connect everything and get no communication between file servers and workstations. Troubleshooting Techniques The following article describes troubleshooting techniques that can be applied to 10Base-T twisted-pair networks. First, know whether your equipment is compliant with the 10Base-T standard, or if it was manufactured before the standard was set "preBase-T".

If distances longer than this are required, two or more segments must be connected using repeaters. The minimum length of a segment should be 2. By using stackable hubs or by cascading regular hubs into a cascaded star topology, you can network large numbers of computers using 10BaseT cable. Although they support up to nodes, collision domains supporting no more than or nodes will yield the best performance.

The maximum length of a 10BaseT cable segment is not a result of the specifications for round-trip communications on an Ethernet network, but rather a limitation caused by the relatively low signal strength of 10BaseT systems. With enhanced category 5 cabling, you might be able to sustain network communications effectively with cable lengths up to about meters, although this is not normally recommended.

When wiring a 10BaseT network, use enhanced category 5 cabling. This would be done for example in the following way:. Extreme 1. Extreme 2. LAN networks are more common today.

By means of this system, the well-known defects of the 10Base2 and 10Base5 networks are alleviated , among them the poor detection of unwanted leads, breaks and loose connectors.

One of the main disadvantages is the installation connected through hubs, which can be expensive and quite complicated for large networks. However, one of the great advantages is the ability to connect new components to the network while it is being used by other computers without having to restart it. Specifically, the cable used, category 3 UTP 25 MHz in lengths of m , consists of four unshielded twisted pairs, of which at least one pair will be used for transmission and another for reception.

The maximum length of the collision domain with repeaters reaches up to m using a coaxial backbone and the maximum number of stations in the collision domain accepted is The cable is connected via an RJ connector to the network card in the computer.